See printed and visual instructions in the attached file below.
Before You Start
Make sure the replacement node is:
Turned on
The node is In Hotspot Mode (Network LED is Flashing GREEN)
Note: in case the Network LED isn't flashing green, follow the below stepsConfigured to the network (online)
Tools Needed
Supplied by the Customer
Android device
Active power source (110-240 VAC/POE)
Supplied by Augury
Halo Node
Step 1: Setting Up the New Node
Node Mounting
Open the HALO Install App
Tap "Field Jobs" tab
Tap on the relevant installation job
Tap the "Plus" button on the bottom right
Tap the node icon
Scan the node SN/Enter SN manually
Fill in the node name
Select Building
Add Locations or notes
Internet settings
Tap "Mount Node"
Node Activation
Supply power to the node
Locate the node to activate
Tap "Activate Node"
Node serial # will appear momentarily
Select the relevant node
Choose the relevant network settings
Tap "Save"
The node will be fully registered on the job screen
Step 2: Replacing the Node in the Halo Installation App
Enter the job in the app
Press and hold on the node you wish to replace. NOTE: if the node does not already have EPs mapped to it, you will only be able to delete it. See step 3, "Deleting the Old Node" for steps.
Tap on "Replace"
Select the node to replace with
Approve the node replacement
Step 3: Deleting the Old Node Out of the Halo Installation App
Enter the job in the app
Press and hold the node you wish to delete. NOTE: if the node already has EPs mapped to it, you will only be able to replace/edit it. See section 2, "Replacing the Node" for steps.
Tap on "Delete"
Approve the deleted node
The network LED is not flashing green.
Hold down the mode button for about ~ 15 seconds until all the LEDs flash orange, then red, then turn off.
The Node will reset itself and change to Hotspot Mode.
The Network LED will be Flashing GREEN.
Click to download the attachment below.